Amerec AK Series 28kW Steam Shower Generator 240V
The Amerec AK-Series 28kW consists of two tandem 14kW steam units and is engineered for home or spa steam showers up to 1100 adjusted cubic feet (ACF). Required control package sold separately. AK steam shower generators includes a stainless-steel tank, industrial-grade heating elements, modular snap-in control connections, durable electronics, an electronic water level control system, and several other innovative features. Available in either 240V/1PH or 208V/3PH configurations. The Amerec AK28 steam bath generator carries a limited lifetime warranty and is fully serviceable. This steam shower unit installs conveniently out of sight in cabinets, closets, vanities, and other similar locations. Amerec steam shower generators are ETL listed to ensure your safety and peace-of-mind.
Features
- Sequential temperature control for consistent flow
- Stainless steel tank
- Industrial grade, serviceable heating elements
- Durable electronic components
- Electronic water-level control system
- Low voltage safety control circuits
- Available Auto Drain automatic draining system
- Ability to field wire in 1-phase or 3-phase
- Ability to connect multiple generators to heat steam baths larger than 1100 cubic feet
- Operates with inside/outside shower, on/off, time/temperature controls
- Full 3/4" port drain valve
- ASME safety valve
- UL/CSA/CE listed
Includes
- 28kW steam bath generator; two 14kw steam generators
- Gang cable
- Note: Does not include additional steam head. First steam head comes with Control package.
- Installation and operation manual
- Limited warranty
Specifications
- Minimum Adjusted Cubic Feet: 900
- Maximum Adjusted Cubic Feet: 1100
- Kilowatt Rating (KW): 28KW
- AC VoltagE: 208V AC
- DC Voltage: 5V DC
- Phase: 3
- Water Supply Connection: (2) 3/8" NPT
- Generator Steam Line Connection: (2) 1/2" NPT
- Steam Head Connection: (2) 1/2" NPT
- Drain Connection: (2) 3/4" NPT
- Safety Relief Valve Connection: (2) 3/4" NPT
- Safety Relief Valve PSIG: (2) 10 PSIG
- Control "Rough In" Cut Out: 2-3/8" Diameter
- Control Sensor Cable: 25', 2 Conductor, 22 AWG, Shielded Cable
- Control Sensor "Rough In" Cut Out: 7/8" Diameter
- Generator Control Connection: 8 Pin, Snap-In Connector
- Generator Control Cable: 25', 8 Conductor, 28 AWG, Shielded Cable
- Width In Inches: (2) 16-1/2"
- Depth In Inches: (2) 6-1/4"
- Height In Inches" (2) 15"
Required control package sold separately.